===============================================================================================
                              FreeRTOS Example Program
===============================================================================================
Copyright(C) Redpine Signals 2016
All rights reserved by Redpine Signals.

This program should be used on your own responsibility.
Redpine Signals assumes no responsibility for any losses
incurred by customers or third parties arising from the use of this file. 

===============================================================================================

===============================================================================================                                                       
Function description:
===============================================================================================
This example will create 3 threads and blinks LEDs in different threads
===============================================================================================
Environment
===============================================================================================
Test Board:
---------------------
Smark EVK 

Assistance software:
---------------------
None

===============================================================================================
Usage Procedure:
===============================================================================================
complile and run the application. on board LED will be toggling 
contineoulsy .
Note:If the companion GPIO board is ported on peripheral board ,then it's not possible to see the 
LED toggling .
===============================================================================================
===============================================================================================
===============================================================================================
Notice:
===============================================================================================
1) Enable DEBUG_UART macro in tool pre-processor window. 
2)The print's content can be observed on any serial terminal  through UART to USB(J21) . 
===============================================================================================